How to Apply Vinyl Lettering:
| 1. Rub your Squeegee or application stick Gently over the vinyl lettering or vinyl designs to make sure they will stick to the transfer tape. |
 |
| 2. Center where you would like the lettering to apply and put a piece of masking tape on the bottom to hold the wording in place. |
 |
| 3. Flip up the lettering (upside down) without removing it from the wall. |
|
| 4. Peel off the white backing slowly and carefully. Make sure all designs and lettering are sticking to the transfer tape! |
 |
| 5. Let the vinyl and transfer tape slowly fall back into place on the surface where you would like to stick the vinyl. |
 |
|
6. Using the
edge of a squeegee, rub or application stick over the
entire design again. Work from the center towards the
edges to remove any air bubbles.
|
 |
|
7. Slowly and carefully remove the transfer tape, beginning in the upper right corner and working at an angle. If any letters are difficult, just use your squeegee to help them transfer to the surface where you would like to stick the vinyl.
|
 |
| 8. You now have some beautiful vinyl lettering. |
 |
